Sma | Lubricants Tillage | Lindstrom Equipment

8" CIH NO-TILL RIPPER POINT

972-87388006

8" No-Till Ripper Point. Fits Case IH 2500 In-Line Ripper. Replaces CNH 87388006.

$93.23

View Details

CHISEL SHANK 1-1/4 X 2 X 26

404-11015

Replacement Chisel Plow Shank for Krause - 26" radius - Length (around curve) 41" - 50° angle. 7/8" top hole, 1/2" on bottom (hole and slot).

$238.83

View Details

BEARING AND HOUSING KIT-KRAUSE DISC

864-SMA1927KIT

Includes 1 each SMA1927L Casting, SMA1927U Casting, SMA1927 bearing and 2 SMA45105 Side Rings.

$224.83

View Details

22X6.5MM PLAIN SEEDER-306001A1

845-P22149

22" x 6.35mm Single Disc Opener Blade, Has 2.525" center hole, 4 holes for 1/2" bolts on 4" circle, Fits Case IH SDX and Precision Disk 30/40 Drills. Replaces 306001A1.

$97.91

View Details

FOOTPIECE FOR 1"X3" SHANK

509-FP1

4" C-C hole spacing, 3/8" steel all welded footpiece. Adjustment slot is open to allow footpiece to trip. Fits Hamby, Roll-A-Cone, CandJ.

$90.13

View Details

FOOTPIECE W/PLATE FRONT&REAR

509-FP1F

Plates have multiple holes Fits 1"x3" shank. 4" C-C hole spacing,

$96.23

View Details

1X3 SHANK 4X4 TOOL BAR CLAMP

509-L44

Toolbar Clamp, Fits 1" x 3" shank and a 4" x 4" toolbar, 3/8" x 6" body with 1" bolts and plated nuts, 16mm set screws.

$83.93

View Details

1X3X30" SHANK W/FP1 FOOT PIECE

509-SF130

All of our Toolbar Shanks are manufactured from C1080-high carbon steel. Our shanks are drilled, not heated and punched, to assure that the temper of the steel is not lost in the heating process and even very long sweeps run level.

$115.34

View Details

1 X 3 X 34" SHANK W/FT PC

509-SF134

All of our Toolbar Shanks are manufactured from C1080-high carbon steel. Our shanks are drilled, not heated and punched, to assure that the temper of the steel is not lost in the heating process and even very long sweeps run level.

$190.83

View Details

Hot Sellers

New Products